[Alexvr4]

Neos, мастер диагностировал. Ошибки которые показывает сканер. АЯК горит красным, тцл и скользская дорога моргают. Все перерыл но нигде нет ответа...

нашел только у буржуя, насколько понял, у него она сама пропала, чтото он там тыкал но сам не понял...

вот дословно

I had ayc error code 31, which I had not bothered to fix as everything seemed to be working ok, but I could not get rid of the code even after a battery disconnect. So it was a real code.
Ayc 31 is steering sensor

I was doing a bit of checking on the abs ecu and solenoids with evoscan, for one of the members on here and I found an odd thing when poking around with the ayc ecu as well.

I started using the activation of the pump and the solenoids etc. Which was all good the pump started and you could hear the solenoids clicking in and out. So I started loving the data and making the steering wheel move and watching evoscan log the angle and speed of movement.

I didn't think any more of it and switch everything offend went in the house for the night.
Next morning when I started the car to go to work, I had left the flashy dash switch on.

And guess what the error code has been removed, I did not try an reset the code via evoscan it just disappeared, I am assuming it must be something I did with the activation of something but what I am not sure.

Maybe someone else with the same error code could try to remedy it be just running through all the ayc a logging options and then the activation items, I am sure I went through them all. It think they are something like, oil level, pump drive, op check Left, op check right, oh and air bleed ( but I did not activate that one).

I seem to remember others on here with a 31 error on the ayc warning light.